Ultra hard wearing performance
A two component water-based PU finish for all types of wood species and cork floors for areas that require a very hard wearing finish. This wood floor PU will out perform your expectations on durability, usability and wear capabilities. Especially suited for very high traffic areas.
• Extremely high abrasion resistance
• Easy to use
• Free of solvents
• Resistant to shoe marks
The professionally sanded and grouted subsurface must be clean and dry, free from oil, wax and dust.
Shake up the regular lacquer well before adding hardener. Mix 471/472/473 evenly and thoroughly with Cross-linker M, in a ratio of 10:1. After 10 minutes stirring, stir again and then use. Do not mix more material together than can be used within 2 hours. Apply strato extreme 47x evenly at minimum 15°C room and floor temperature in 2-3 coats with the Aquatop-Roller. Interim sanding between coats with abrasive mesh 120.
approx. 120-130 ml/m² per coat (8 m²/l). For best results and an even surface image, work in thick layers. In the case of highly absorbing subsurface increased consumption of the prime coat is possible, depending on the absorbency of the wood.
For the sake of the wood and the avoidance of excessive swelling, only one rolled coat per day is recommended. Can be walked on carefully, or worked on again, after about 3 hours (at 23 °C and 50% relative humidity). The area should not be mopped wet in the first 3 days. After 10 days at the earliest the floor can be cared for, or carpets laid on it.